Ashly NXE3.04 Specs Channels 4 Maximum Output Power Max Output Power Per Channel, Low Impedance Output, All Channels Driven 2 Ohms: 3000 W, 4 Ohms: 2000 W, 8 Ohms: 1250 W Low Impedance Output, Bridge Mode, All Channels Driven 4 Ohms: 6000 W 8 Ohms: 4000 W 70 V, 100 V Output, All Channels Driven 70 V (per channel): 2450 W 100 V (per channel): 1250 W Power Draw Total Power Draw All Channels Driven Sleep Mode: <1 W Standby Mode: 70 W Idle (no signal): 100 W Current Draw Current Draw 120 VAC Mains (divide in half for 240 V) Sleep Mode: 0.1 A Standby Mode: 1.3 A Idle (no signal): 1.85 A Maximum Current Draw All Channels Driven, Divide by 2 for 240 VAC 1/8 Maximum Power @ 2 Ohms: 29.5 A Dissipation Thermal Dissipation BTU/hr, Total for All Channels Driven Sleep Mode: <3.4 Standby Mode: 238 BTU/hr Idle (no signal): 340 BTU/hr 1/8 Maximum Power @ 2 Ohms: 2720 BTU/hr Voltage Gain Selectable at 26 dB, 32 dB, 38 dB, or 1.4 V Damping Factor >250 (8 Ohms load <1 kHz) High Pass Filter Input: 80 Hz 2nd order Distortion SMPTE, typical: <0.5% THD-N, typical: <0.5% (8 Ohms, 10 dB below rated power, 20 Hz to 20 kHz) Channel Separation -75 dB (dB from full output, 1 kHz) Signal-to-Noise Ratio 20 Hz to 20 kHz, Unweighted: >114 dB Frequency Response 20 Hz to 20 kHz, +/-0.05 dB Input Connector Balanced: Euroblock 3.5 mm, 1/4" TRS and XLR combo jack Input Impedance 10 kOhms Maximum Input Level +21 dBu Output Connector Speaker: Neutrik speakON AUX: Balanced Euroblock 3.5 mm Network Control Network: Compatible with standard 100 MB Ethernet Aux Output Level Maximum: +21 dBu Contact Closure Remote Standby: Euroblock 3.5 mm, close contact to GND for standby mode Preset Recall: Euroblock 3.5 mm, close contact to GND for preset 1-4 recall Supported Data Connections Euroblock 3.5 mm - Gnd, +18 V, In, Out Logic Output Fault Condition: Euroblock 3.5 mm - 4 available Level Control Remote DC: Euroblock 3.5 mm - Gnd, CV, V+ per input Active Attenuators Per Channel: Front panel, software, offset link group, and remote Fully Off: Mute Amplifier Protection Inrush current limitation, temperature monitoring, output over-power protection, mains fuses Cooling Continuously variable temperature controlled axial fan(s) Environmental 32 to 113°F (0 to 45°C) (non-condensing) Front Panel LED Indicators POWER (white): Switch: On, Off, Standby (flashing) PROTECT (red): On (fault condition or shut down), Off SLEEP (blue): On, amplifier is asleep from audio inactivity DISABLE (yellow): On, power switch & front panel attenuators are disabled Per Channel CLIP/MUTE (red): Clip @ 1 dB below full output / Mute SIGNAL (green): -18 dB below rated output CURRENT (green): Proportional to output TEMP (yellow): On dim at 90% max operating temperature, full bright + protect at 100% BRIDGE (green): On, Off Power Requirements @ 50/60 Hz Nominal (Automatic Sensing SMPS): 120 to 240 VAC Operating Range: 70 to 135 VAC to 140 to 270 VAC Minimum Power-Up: 85 to 170 VAC Power Cable Connector: 20 A powerCON Compliance cTUVus, CE, FCC, RoHS Dimensions 19 x 3.5 x 16.84 (483 x 89 x 428 mm) Weight 28.7 lb (13 kg)